Posted on

The problem: Your motor has failed and you need to remove it from your machine. You have disconnected all the electrical, disconnected the coupling, cursed the engineer who designed the machine, and are now ready to remove the motor. There is just one obstacle left however, the motor weighs way more than you can lift by hand.

The solution: You decide to use a forklift or ceiling crane to lift the motor out of the machine. You see that the motor has one or two eye-bolts that you can attach slings to. Just connect the motor to the crane and lift right? Almost, but there are a few things you must do to insure your personal safety and the safety of the motor.

Sling Basics

  • Never exceed rated load.
  • Never use sub-part sling.
  • Do not use slings missing labels.
  • Rated load decreases as angle lessens.
  • Reduce strain on sling where possible.
  • Be sure eyes fit freely on hook.
  • Full wrap rope before choke.
  • Reduce strain on bolts where possible.
  • Use one sling per eye-bolt.
  • Always lift eye-bolt straight up.

Using a Sling:

Slings Are Specifically Rated for Certain Loads

These loads vary depending on the manner in which you utilize the sling. These loads should be documented on the sling label. If the label is missing or you are using a sub-par sling you should consider throwing it away and investing in proper slings.

Learn the Right and Wrong Ways to Attach a Sling

Wear-flex has a web page on the proper use of their slings. Knowing when a sling is being used improperly will reduce the likelihood of undue strain leading to sling failure.

Always Use One Sling Per Eye-Bolt

Never loop the sling through two eye-bolts. This mistake is common. When the sling loops from one eye-bolt to another it puts force on the bolts at an improper angle that can lead to them bending or breaking. Always lift an eye-bolt straight up from the top of the bolt, and check that the bolt is tight before lifting.

In Summary

These are some tips on safely lifting your motor out of your machine and putting it back in. If you decide that you want your motor professionally repaired, send it to Servotech Inc. We have all the necessary knowledge and equipment to rebuild your servo motor.